Minimum Version Required:
2.5.25 - 3.1.0.18311 for Yealink support
Installation Notes:
To perform an installation you will need the IP address of the PBX and the system username and password. You will also need to ensure that each extension's "partner code" is set as the extension number.
Directory Download:
Extensions
Advisories:
The Maximiser supports an "off hook working" mode.
This mode should be used at the user's discretion.
Blind transfer, deflect and pickup are not supported.
Call ID is not retained on transfer calls.
DDI is not sent to the client, Extension or group number is presented.
NOTE: if the Partner Code password is wrong the extensions will download but will show offline.
Yealink handsets supported in PBX builds SV1.2.57 >
This PBX will be end of life from March 2020.
5000 maximum devices this includes, extensions, call groups, Departments.
Type:
Proprietary / LDAP
Requirements:
System username and password
Partner Code
Firewall Requirements:
TCP: 389 (LDAP)
TCP: 4000
Architecture:
This PBX will be replaced by the SelectVoice (SV) and will be end of life March 2020.
The SpliceCom Maximiser connects onto the LAN via the RJ45 socket on the front of the PBX. The local IP address and other network settings are set through the HTML-based programming interface.
Driver Requirements:
None
Firmware Requirements (for new installations):
SV1.2.57 last tested
Type | Make Call | Hang up | Answer | Deflect | Blind Transfer | Supervised Transfer | Hold | Pick up | Send DTMF | Call Fwd | Dialback |
---|---|---|---|---|---|---|---|---|---|---|---|
Splicecom Handsets |