Minimum Version Required:
To perform an installation you will need the IP address of the PBX. You will also need to configure an AMI username and password on the PBX.
We cannot connect to the "MyPBX S-series"
MyPBX is a classic Asterisk deployment on dedicated hardware. It supports ISDN and SIP trunks, plus a range of third party handsets. Configuration is done using the HTTP interface.
Firmware Requirements (for new installations):
220.127.116.114 or later
Recent firmware is required (18.104.22.1684 or later) to give full call control. Also "call waiting" should be disabled on the handsets to allow consultation to be used.
|WAN Connectivity||Trunk Monitoring||Analog Phones Supported||Agent Features Supported|