Siemens Hipath 3000

Connection:	CSTA Phase III and SNMP
Driver required:	None required
Firewall ports required:	UDP: 161 (SNMP) TCP: 7001
Firmware version required: (for new installations)	5 or later
Other requirements:	A network interface is required. The LIM module or the HG1500 are supported. (Note: Siemens do not recommend the use of the LIM interface in a large scale deployment)
Directory download:	Extensions only

Architecture

The Siemens 3000 series area available in two formats: wall mounted or rack mounted. The module number denotes the format: 3x00 for rack mounted and 3x50 for wall mounted. Configuration of the telephone system is performed using either the Manager E software (for engineers) or the Manager C software (for customers). All CSTA and SNMP related options should be left at their default values.

Go Connect Server Installation Notes

To perform an installation you will need the IP address of the telephone system. PLEASE NOTE: this is not the IP address of the VoIP gateway, but the PBX itself (or LIM / HG1500). You will also need to know the range of trunk numbers.

Advisories

Handsets without speakerphones (including DECT and analog) do not provide a full range of handset control. Internal hold is not supported by Siemens. It makes a beep if attempted. Call direction and/or dialed number may be wrong in some call pickup scenarios. Multiple Line Appearances (MULAPS) are not fully supported. They may lead to stuck calls or incorrect directions.